2CL-001
CENTRAL LOCKING KIT
- Electro-Mechanical activation
This module uses negative lock and unlock signals from a remote alarms/immobilisers to mechanically operated the lock mechanism of a car door
- Master and slave actuators
Each kit uses a master actuator for each front door, and a slave actuator for the rear door (4 in total). Master actuators control all actuators
- Full complement of hardware
Supplied with all metal brackets, superior 3 point fixing clamps with slot / cross head screws, rods, worms, speed nuts and cabling required for standard installation
- Intelligent switch controller
Includes active central locking controller
- Pre-loomed wire harness
Generous wire loom to connect four doors, all wires fully sheathed
- Wide Operating voltage
Operating voltage +9VDC to +15VDC
- Operating temperature
-20 degrees to +85 degrees for equipment designed to be installed within vehicle cabin
- Polarity protection
The system circuitry is design to protect itself against accidental battery polarity reversal. This can happen when replacing the vehicle battery
- Short circuit protection
The power supply wire to the system is protected against an internal fault within the system
- Current rating
All relays rated to carry 15amps continuous, connector 8amps continuous
- Compatible with Cyclops remote control systems
Cyclops range of immobilisers/alarms : P355, P375, P375B, P385, P755, P775, P775B, P785, KE-CLR-TX90, KE-CLR-TX11, S35i, S35B, S35C, S75i, S75B and S75C
- Manufactured to international standards
Produced in accordance with UNI-ES-ISO 9002
** Product images are for illustration purposes only. Actual appearance may vary slightly without notice.
Product Catalogue