4CL-002
REMOTE CENTRAL LOCKING KIT
- Master and slave actuators
Each kit uses a master actuator for each front door, and a slave actuator for the rear door (4 in total). Master actuators control all actuators
- Full complement of hardware
Supplied with all metal brackets, superior 3 point fixing clamps with slot / cross head screws, rods, worms, speed nuts and cabling required for standard installation
- Intelligent switch controller
Includes active central locking controller
- Remote activation
The central locking kit can also be operated by remote control 
- Two polycarbonate remote controls
Rolling code encoder with over 18,000,000,000,000,000,000+ code combinations, transmitting via 433MHz PWM RF signal
- Large system memory
Allows system to track five controllers
- Controller re-programming
Service technician can delete lost or stolen controllers from memory
- Pre-loomed wire harness
Generous wire loom to connect four doors, all wires fully sheathed
- Arm/Disarm confirmation
System flashes car indicators when arming or disarming
- Wide Operating voltage
Operating voltage +9VDC to +15VDC
- Operating temperature
-20 degrees to +85 degrees for equipment designed to be installed within vehicle cabin
- Polarity protection
The system circuitry is design to protect itself against accidental battery polarity reversal. This can happen when replacing the vehicle battery
- Short circuit protection
The power supply wire to the system is protected against an internal fault within the system
- Current rating
All relays rated to carry 15amps continuous, connector 8amps continuous
- Manufacturers warranty
Guarantees product is free from manufacturing defects for 12 months from time of purchase 
- Manufactured to international standards
Produced in accordance with UNI-ES-ISO 9002
Legend:
Will categorically need extra hardware and connections.
May require additional hardware or connections.
Additional relay and connection required in vehicles with boot solenoid. Relay and solenoid kit required for vehicle without solenoid.
Vehicle circuit polarity may require addition components to convert voltage.
Special order required - this is not part of the standard hardware.
Special feature out of Dynamco's control.
Conditions apply.
Programmable option.
Due to model and manufacturer variations, specifications of actual product may differ from those shown.
Conditions apply.
Programmable option.
** Product images are for illustration purposes only. Actual appearance may vary slightly without notice.
Product Catalogue